Spare or replacement UBOBIII card
Check your UBOB III rev level printed on the card. There are two choices. For the UBOBIII rev 9 to rev 14 select the rev 14 option (older UBOB). For newer system with Ethercut using either ESS card for MACH or the MESA card for LINUX select the rev 15/16 card.
The Rev 15/16 does not have a serial port (9 pin) and the parallel port on the card is a header to plug to the ESS or MESA cards.
Both of these cards are out of production and are sourced from rebuilds and are re-certified.
NOTE: If you have an old rev UBOB with lower rev than rev9 you can still use the rev14 BUT you will have to modify the mounting to mount the 3 tab regulator AND the card runs off JUST a 12VDC source.
NOT ALL UBOB’s are in Stock . There may be a delay while stock cards are tested and re-certified.
Please be aware that the MACH3 system is obsolete and no longer supported. Our Tech support team does not know MACH or how to install and setup. There are Master Installers on our website for legacy products. While there is a warranty on refurbished boards it does not include phone support. All support must be via the Support Forum and/or email
No returns or refunds on Replacement Parts.