Description
Cable for Hypertherm PowerMax Series with rear CPC connector or newer A series Thermal Dynamics with CPC connector and internal voltage divider. Connects directly from CPC to PWMII module.
This model is made to plug into the PWMII (only). It has the correct connectors and an inline cable filter for use with CommandCNC rev 1.1 when using AutoSet.
If you have an older PWM it needs to be replaced with the PWMIIA and the older MIC-01 cable modified with a new 4 wide connector. PWMIIA still has the stereo plug (besides the new 2 wide)
MIC-03A Cable (With cable filter)
$120.00
This model is made to plug into the PWMII (only). It has the correct connectors and an inline cable filter for use with CommandCNC rev 1.1 when using Auto Set. NOTE: Photo is of cable without heat shrink to show detail. Cables come with filter card and wires covered.
Do not use this cable with the PWMIIA or the older PWM models.
Description
Cable for Hypertherm PowerMax Series with rear CPC connector or newer A series Thermal Dynamics with CPC connector and internal voltage divider. Connects directly from CPC to PWMII module.
This model is made to plug into the PWMII (only). It has the correct connectors and an inline cable filter for use with CommandCNC rev 1.1 when using AutoSet.
If you have an older PWM it needs to be replaced with the PWMIIA and the older MIC-01 cable modified with a new 4 wide connector. PWMIIA still has the stereo plug (besides the new 2 wide)
Additional information