Description
Cable for Hypertherm PowerMax Series with rear CPC connector or newer A series Thermal Dynamics with CPC connector and internal voltage divider. Connects directly from CPC to PWMII module.
This model is made to plug into the PWMIIA (only). It has the correct connectors and no inline filter. While it will work with an older PWMII, it will not work properly with newer Hypertherm Powermax nor the new Autoset in CommandCNC.
If you have an older PWM (stereo input only), it needs to be replaced with the PWMIIA and the older MIC-01 cable modified with a new 4 wide connector. PWMIIA still has the stereo plug (besides the new 2 wide).
MIC-03 Cable (No cable filter)
$95.00
This model is made to plug into the PWMIIA (only). It has the correct connectors for use with CommandCNC rev 1.1 when using AutoSet. NOTE: Photo is of cable without heat shrink to show detail.
Do not use this cable with the PWMII or the older PWM models
The PWMIIA has built in INTERNAL filtering so can use a non-filtered cable.
Description
Cable for Hypertherm PowerMax Series with rear CPC connector or newer A series Thermal Dynamics with CPC connector and internal voltage divider. Connects directly from CPC to PWMII module.
This model is made to plug into the PWMIIA (only). It has the correct connectors and no inline filter. While it will work with an older PWMII, it will not work properly with newer Hypertherm Powermax nor the new Autoset in CommandCNC.
If you have an older PWM (stereo input only), it needs to be replaced with the PWMIIA and the older MIC-01 cable modified with a new 4 wide connector. PWMIIA still has the stereo plug (besides the new 2 wide).
Additional information