Made to fit the new G5A case to provide a 5th axis expansion option for rotary cutting the G5A Solo Axis is a plug and run module that takes 4 screws to mount and plugs to the same motor interface module (MAT250) as the dual axis modules. The G251X driver is mounted on a heatsink and isolated ,. Module comes with 10 pin signal cable and 2 wire DC voltage cable to connect back to the UDCM . The install takes less than 15 minutes and most of that is software settings in CommandCNC™.
G5A Solo Axis Expansion Module
$165.00
Description
Made to fit the new G5A case to provide a 5th axis expansion option for rotary cutting the G5A Solo Axis is a plug and run module that takes 4 screws to mount and plugs to the same motor interface module (MAT250) as the dual axis modules. The G251X driver is mounted on a heatsink and isolated ,. Module comes with 10 pin signal cable and 2 wire DC voltage cable to connect back to the UDCM . The install takes less than 15 minutes and most of that is software settings in CommandCNC™.
Additional information