Description
NEW! Improved – here NOW!
The Feather Touch Ohmic Sensor Kit makes your torch tip a highly sensitive touch sensor by sensing when the tip touches a piece of metal on the table. Virtually zero down force is applied so it is perfect for cutting thin materials. It will not push down bowed or warped material during the touch-off sequence so there is no “spring back” error like there can be using the Floating Torch Holder alone. Hookup and setup should take just a few minutes. Detailed instructions included.
Comes with:
- FT-02 Ohmic Sensor Module
- 9 to 14VDC wall plug transformer (120VAC only)
- 20 ft multi conductor stranded cable, connected at the Sensor end and tested, included (longer sections available).
- Direct 12 pin to 12 pin connector for use with new Table I/O 17 used in G5 series connectors (select from options) or older single 12 pin cable for older.
- Expanded inputs for 4 more gantry mounted inputs. Mount your X and Y-Y’ homes on the gantry and just plug them to the FT-02. Top mounted plugs for inputs.
- Support for 12V NPN sensors (Proximity and Optical). Special Internal DUAL input “OR” circuit lets you use a dual sensor setup for breakaway or other sensing. (May not be available on older 12.2 cards)
FT- 02 Feather Touch Ohmic Sensor
$157.00
FT-02 Feather Touch Ohmic Sensor. Supports powered (12V) sensors. On 12.6 or rev 17 (G5) cards. More connections to support more inputs. Single 12 pin locking connector. Requires Ohmic sensor connector on the torch (not furnished). Uses connection between the torch shield and the work (plate/metal) to sense the touch off. Virtually no down pressure. NOTE: SUPER Z product has FT-02 BUILT IN so this is not required on those installs.
IMPORTANT: The FT-02 is designed to be plug and run with CandCNC controllers that have the newer 12.2 up to 12.6 Table I/O card or Table I/O 17 We do not sell this for use on other brands of controllers and we will not provide support (how to hook it up or troubleshooting ) for use on anything but CandCNC plasma controls with DTHCIV/DTHC5. No refunds or warranty on units not used with CandCNC certified equipment. This is not compatible with the older CandCNC systems that do not have the Table I/O models listed. In most cases older controllers can be updated with newer Table I/O.
Description
NEW! Improved – here NOW!
The Feather Touch Ohmic Sensor Kit makes your torch tip a highly sensitive touch sensor by sensing when the tip touches a piece of metal on the table. Virtually zero down force is applied so it is perfect for cutting thin materials. It will not push down bowed or warped material during the touch-off sequence so there is no “spring back” error like there can be using the Floating Torch Holder alone. Hookup and setup should take just a few minutes. Detailed instructions included.
Comes with:
Additional information