EtherCut Mach to EtherCut Linux + CommandCNC + Computer Upgrade, This is for the Router Version (no DTHC).
NOTE: Before purchasing this upgrade, please contact us to ensure your current product will support this upgrade. Some of the older systems will not work with this upgrade, and if attempted it could cause damage to your system and will void the warranty.
Contact Tom at tom@candcnc.com to verify your system is compatible with this upgrade.
This is for upgrading any previous DTHC version to an EtherCut Linux based control and a computer.
Sub-Assembly and Refurbished Linux computer with:
UBOB III REV 16*
High Speed Ethernet
Linux Computer with CommandCNC™ software
Router Config file and Screens.
Router POST for SheetCAM for CommandCNC™
NOTE: The 4 Port Hub is NOT required and not included. You only need ONE if you are adding the PN200 hand controller. Hub is REQUIRED with the DTHC (Plasma systems).
EtherCut Linux Router (only) + CommandCNC Upgrade
$990.00
EtherCut Mach to EtherCut Linux + CommandCNC + Computer Upgrade, This is for the Router Version (no DTHC).
NOTE: Before purchasing this upgrade, please contact us to ensure your current product will support this upgrade. Some of the older systems will not work with this upgrade, and if attempted it could cause damage to your system and will void the warranty.
Contact Tom at tom@candcnc.com to verify your system is compatible with this upgrade.
Description
This is for upgrading any previous DTHC version to an EtherCut Linux based control and a computer.
Sub-Assembly and Refurbished Linux computer with:
NOTE: The 4 Port Hub is NOT required and not included. You only need ONE if you are adding the PN200 hand controller. Hub is REQUIRED with the DTHC (Plasma systems).
Additional information