The Digital Current Probe works with all plasma cutters. The DCP-01 allows you to see the actual DC Amps AT THE CUT using our exclusive DCP Add-on module for the DTHC. It is accurate within better than 2% across a range of 20 to 125A (higher range version available on request). Displayed in real time on the same screen as the TORCH VOLTS, it gives you precise information about your plasma cut. No longer do you have to guess at what the true cut current is. Use the Cut Profile to preset fault points so you can prevent bad cuts due to improper dial settings or poor work clamp connections. The DCP also acts as an adjustable ARC OK sensor and it works with any plasma cutter. Each Cut Profile can have it’s own ARC OK trip value in AMPS.
NOTE : Max continuous (cutting current) is 100A. Maximum surge (peak) is 150A. Exceeding these limits voids the warranty.