A NEW faster way to build simple or complex multi-axis CNC projects.  Designed to be a general remote Step & Dir interface it supports connection to virtually any CandCNC product.  Shipped as standard equipment with the MP1000 series, It's now available for use our other products. Quick Info in the MTA100 Mass Termination Adapter: A way to plug Breakouts (Mini-IO) and the Integrated Dual Combo/Super Combo and the MP1000 series to downstream motor drives, power controllers and front panel cards Small footprint Uses IDC and Ribbon cables for inter-connects (included) Screw terminal breakout for direct Driver card interface if needed (4 axis) Usable with all CandCNC Breakout and Integrated Control Box Allows single cable connection to CandCNC Gecko EZ Plug Interface Cards Has option jumpers for Gecko Common and external power for larger encoders Allows direct connection of new CandCNC PSC "D" series Power Controllers Included with all MP1000 products and Mini-IO Super Combo Usable with other drives that use step & dir signals (hard wired) Plug for older remote CandCNC RUN/STOP front panel Plug for optional Step & Dir monitor card (SD-04) for 4 axis Supports new 5.5 axis MP1000 "B Series" Double buffered S&D for clean signals $29.95 with basic cable set.  The MTA100 was developed primarily to allow our Gecko Interface cards (servo or stepper) to quickly plug and go with any of our existing solutions.  Before, the interface cards worked only with our larger PSC650/1500 Power controllers.  Our Gecko Interface cards are the fastest way to connect and control Gecko Servo and Stepper Drives.  Shown at the right is a 4 axis servo hookup using an inexpensive MINI-IO and two of our Gecko Dual Servo Interface Cards.  These interface cards have the Power on Reset, Central Fault Detection (any gecko fault trips a signal) and full Differential Encoder Driver/Receivers for interference free operation. For block diagrams of this and other connection setups please select from the list below.